Note: Not all V2000-c variants include an internal RTC battery. Check your model.
31 1 0900 1700 12345 # (12345 = Mon-Fri).The manual emphasizes the following:
| Step | Action |
| :--- | :--- |
| 1 | Press * + Master Code + # |
| 2 | Press 1 (Add User) → # |
| 3 | Swipe card (beep 1x) |
| 4 | Enter 4–6 digit PIN → # |
| 5 | Swipe same card again to confirm → # | V2000-c Rfid Access Control User Manual
The V2000-C is designed for durability and simplicity. Unlike biometric fingerprint scanners, the RFID + PIN keypad is reliable in dirty, wet, or outdoor environments where fingerprints might fail. It is ideal for construction sites, warehouse gates, and back-entrance doors. Note: Not all V2000-c variants include an internal
If you need the specific section regarding programming the Master Code or the Wiring Diagram, let me know and I can provide the generic steps for this model. Time Zone 1 (9 AM – 5 PM
| Problem | Likely cause | Solution |
|---------|--------------|----------|
| No power | Wrong voltage | Check 12V DC, min 1A |
| Card not beeping | Wrong RFID frequency | Use correct card type (125kHz EM) |
| Green LED but lock doesn’t open | Relay wiring wrong | Check NO/COM or NC/COM based on lock type |
| Buzzer long beep after card | User not enrolled | Add user via programming |
| Door open too long alarm | Door contact stuck | Adjust sensor position or disable with 04 0# |
Date: [Current Date] Prepared For: Security System Administrators / End Users Subject: Functional Overview, Installation Guidelines, and Operational Procedures