Ttl Models Carina Zapata 002 Install →

Resin is heavy. If you simply glue the Carina Zapata 002’s arms, they will snap off under their own weight in six months. Pinning creates a metal skeleton.

For each arm-to-shoulder joint:

For the head-to-neck joint: Use a 2mm drill bit and a longer brass rod (15mm). The head is top-heavy. Drill through the neck stump, through the torso cavity, and install a rod that anchors deep into the chest area. This prevents the "head lean" that plagues many Carina Zapata builds. ttl models carina zapata 002 install

For the base connection: Drill two 2mm holes 20mm apart into the bottom of the torso. Drill matching holes into the resin base. Use two brass rods as alignment pegs. This also allows you to paint the bust and base separately.

The downloaded archive (TTL_Carina_Zapata_002_v1.0.zip) contains the following directory structure: Resin is heavy

Subject: TTL Models: Carina Zapata 002 Document ID: TTL-CZ002-INST-2024 Target Environment: Digital Content Creation (DCC) Software (e.g., Blender, Maya, 3ds Max)

The gap between the body and over-fenders is inevitable. Apply Tamiya Basic Putty, wait 1 hour, then wipe away excess with lacquer thinner on a cotton bud. Re-sand with 800 grit. For the head-to-neck joint: Use a 2mm drill

The kit includes separate resin arches. Do not glue them yet.

TTL models are calibrated for High Dynamic Range Imaging (HDRI).

TTL Models casts parts with thick attachment gates. Use a razor saw (not a knife) to remove the body from its pour stubs. Sand the nubs flush with 400-grit wet sandpaper.

The biggest challenge of the ttl models carina zapata 002 install is the lack of a mechanical engine. TTL assumes you will display it "hood closed."