Siemens Cashpower 2000 Pre Paid Meter User Manual -

If you try to enter the same 20-digit code twice, the meter will display Error 10 or “Already Used.” This is a security feature to prevent fraud. You do not lose credit if this happens.

You can check your current status without entering a token. Typically, pressing the *Info (or ) button scrolls through the following screens:

Note: On some Cashpower 2000 models, the meter automatically cycles through this information on the screen every few seconds.

This is the most critical function of the meter. Follow these steps carefully: siemens cashpower 2000 pre paid meter user manual

The Siemens CashPower 2000 is a single-phase prepaid electricity meter that uses token-based credit top-ups. It displays credit balance, energy usage (kWh), and status messages on an LCD. Users purchase tokens (numeric codes) from authorized vendors and enter them into the meter to add credit. The meter disconnects supply when credit reaches zero and can be configured to issue low-credit warnings.

Many Siemens Cashpower 2000 meters are configured for Prepaid TOU. This means electricity costs more during "Peak" hours (e.g., 5 PM – 9 PM) and less during "Off-Peak" hours (e.g., overnight).

Unlike modern smart meters, the Cashpower 2000 uses a text-based menu system. Press the Scroll (S) button repeatedly to cycle through these displays: If you try to enter the same 20-digit

| Display Screen | What it means | | :--- | :--- | | 1.0.0.0 or Remaining Credit | The current available balance (kWh or local currency). | | 1.8.0.0 | Total cumulative energy consumed since installation. | | 2.8.0.0 | Power On/Off status or tamper flag. | | A (Followed by numbers) | Active tariff rate or emergency credit status. | | Error XXXX | Fault code (See Section 6). |

Pro Tip: If the meter shows LOCK or OFF, it means the internal breaker has tripped due to reaching zero credit or a load limit violation.

Unlike modern smart meters, the Cashpower 2000 uses a keypad. Here’s the exact process: Note: On some Cashpower 2000 models, the meter

Pro tip: Always enter the entire 20 digits without pausing too long. If you make a mistake, press the red # button to clear and start over.

Don’t panic if you see an error. Here’s the Siemens Cashpower 2000 troubleshooting guide:

| Error Code | Meaning | Solution | |---|---|---| | reject | Token invalid or already used | Re-enter carefully. If repeated, the token may be for a different meter number. | | Err 01 | Incorrect token format | Check for double-entry of digits. Power cycle the meter (isolate the breaker for 30 seconds). | | Err 05 | Token already used | You cannot enter the same token twice. Request a new token from your vendor. | | rE=0 | Credit depleted | Immediately recharge to avoid disconnection. | | dE with a number | You have debt | Enter a token that covers both new credit + the debt amount. |