Me7.4.5 Pinout < Trending >

You can log AFR by tapping the wideband’s 0-5V analog output into an unused ME7.4.5 analog input. Common choices:

| Pin No. | Function | Description / Signal | | :--- | :--- | :--- | | A01 | Output Stage Ground | Ground for ignition coils (Critical) | | A02 | Signal Ground | Sensor ground return (MAP, T-MAP, etc.) | | A03 | Battery Voltage (+12V) | Switched power supply (via Main Relay) | | A04 | Ignition Coil 1 | Cylinder 1 trigger signal | | A05 | Ignition Coil 2 | Cylinder 2 trigger signal | | A06 | Ignition Coil 3 | Cylinder 3 trigger signal | | A07 | Ignition Coil 4 | Cylinder 4 trigger signal | | A09 | CAN High | CAN-Bus Communication (High Line) | | A10 | CAN Low | CAN-Bus Communication (Low Line) | | A16 | T-MAP Sensor +5V | 5 Volt supply for Manifold Pressure Sensor | | A17 | T-MAP Signal | Manifold Absolute Pressure Signal | | A20 | Oxygen Sensor Signal | Pre-cat O2 Sensor Signal | | A21 | Oxygen Sensor Ground | Pre-cat O2 Ground | | A27 | Coolant Temp Signal | Engine Coolant Temperature (ECT) Sensor | | A28 | Intake Air Temp Signal | Intake Air Temperature (IAT) Sensor | | A29 | Throttle Position 1 | Potentiometer 1 (Electronic Throttle) | | A30 | Throttle Position 2 | Potentiometer 2 (Electronic Throttle) | | A31 | Throttle Motor + | DC Motor control (positive) | | A32 | Throttle Motor - | DC Motor control (negative) | | A35 | Vehicle Speed | Speed signal from ABS/Transmission | | A39 | K-Line | Diagnostic Line (OBDII Port) | | A42 | Power Steering Pressure | Power steering pressure switch input | | A62 | Accelerator Pedal 1 | Accelerator Pedal Position (APP) Sensor 1 | | A63 | Accelerator Pedal 2 | Accelerator Pedal Position (APP) Sensor 2 | me7.4.5 pinout

Factory Volkswagen/Audi diagrams label pins in this format: T121/57 = Connector T121, Pin 57.
Cross-reference with the table above. Also note: You can log AFR by tapping the wideband’s

The ME7.4.5 utilizes two main connectors plugged into the side of the unit. pins are numbered left-to-right

Note: Pin numbering follows standard Bosch conventions (looking at the ECU pins from the harness connector side, pins are numbered left-to-right, top-to-bottom).

| Pin Number | Pin Name | Description | | --- | --- | --- | | 1 | VBATT | Battery voltage supply | | 2 | GND | Ground | | 3 | VREF | Voltage reference |