Update | Linkrunner At 2000 Firmware
Here is the official method using LinkRunner Manager.
A firmware update might transform your LRAT-2000. Features like TruePower™ 802.3bt load testing or IPv6 discovery are often added post-launch.
The LinkRunner AT 2000 firmware update is essential for maintaining the device's diagnostic accuracy and ensuring compatibility with the Link-Live Cloud Service . Keeping your network tester updated allows you to access improved AutoTest features and the latest security patches. Preparing for the Update Before starting, ensure you have the following:
A Valid Support Contract: Most official firmware updates require an active AllyCare support contract .
Power Source: Ensure the unit is fully charged or connected to power to prevent failure during the installation.
Required Hardware: A standard USB cable provided with the unit to connect to your PC. Step-by-Step Update Process
The LinkRunner AT 2000 does not support direct over-the-air updates; it must be updated locally using the LinkRunner AT Manager application on a Windows PC. linkrunner at 2000 firmware update
Download Software: Log in to your Link-Live.com account, navigate to Support > Software Downloads, and download the LinkRunner AT Manager and the latest firmware .zip file. Note: Do not extract the firmware .zip file.
Connect Device: Connect your LinkRunner AT 2000 to the PC via USB and launch the LinkRunner AT Manager. Initiate Update:
In the Manager software, click Tools and select Update Firmware.
Click Select, browse to find your downloaded .zip file, and click Open.
On the device itself, you may need to navigate to Tools > Firmware Update and press Select or F1 (Update) to confirm the connection.
Complete Installation: The process typically takes about 5 minutes. The unit will reboot during this time; do not disconnect the USB cable until the software confirms the update is finished. Important Versions LinkRunner AT Manager and Updating Software - NetAlly Here is the official method using LinkRunner Manager
Updating the firmware on a NetAlly (formerly Fluke Networks) LinkRunner AT 2000 ensures you have the latest testing capabilities and bug fixes. The update is typically performed using a Windows PC and the LinkRunner AT Manager software. Prerequisites
A Windows PC with the latest LinkRunner AT Manager software installed.
USB Cable (Mini-B to USB-A) to connect the tester to your computer.
Firmware Update File: Download the latest .zip patch from the NetAlly Support page or your Link-Live account. Note: Do not unzip the firmware file after downloading. Step-by-Step Update Guide 1. Connect the Device Power on your LinkRunner AT 2000. Connect the tester to your PC using the USB cable. 2. Prepare the Tester On the LinkRunner home screen, select Tools. Scroll down and select Firmware Update.
Press the F1 key (labeled Update) to put the device into update mode. 3. Run the Update via LinkRunner Manager Open the LinkRunner AT Manager software on your PC. Click the Tools menu at the top. Select Update Firmware.
Click Select and browse to the location where you saved the firmware .zip file. Follow the on-screen prompts to begin the transfer. 4. Complete the Installation The LinkRunner AT 2000 firmware update is essential
The software will upload the file to the tester. This process typically takes about 5 minutes.
Once the upload is finished, the tester will verify and install the firmware automatically.
Do not disconnect the USB cable or power off the device until the process is complete and the tester restarts. Verifying the Update After the device reboots, you can verify the new version: Go to Tools. Select LinkRunner Information.
Check the Software Version to ensure it matches the version you just installed. LinkRunner AT Manager and Updating Software - NetAlly
Run the installer on your PC. Disable Windows Firewall temporarily if the software fails to detect the tester later.