Etv 216 Error Codes | Jungheinrich

Important: Always record the exact code before turning the truck off or disconnecting the battery.

On the dashboard display, you will typically see a code starting with a letter followed by numbers (e.g., E 101).

Have a code not listed here? Post it in the comments below (include the full code and any flashing light pattern). Many Jungheinrich techs follow this blog and are happy to advise.

Disclaimer: This content is for informational purposes only. Always refer to official Jungheinrich documentation for your specific ETV 216 serial number range (typically S/N 653xxx or higher). Incorrect repairs can cause injury or damage. jungheinrich etv 216 error codes

Error codes on a Jungheinrich ETV 216 reach truck typically indicate issues with the electrical system, sensor data, or mechanical safety switches. Most codes prompt the truck to inhibit travel or lifting to prevent further damage. Common Jungheinrich ETV 216 Error Codes

Discussion: Jungheinrich ETV 216 Error 047 - Forklift Action

Meaning: The hydraulic pump motor has exceeded 120°C (248°F). Important: Always record the exact code before turning

Symptoms: Total loss of lift and tilt functions. Cooling fan runs at maximum speed.

Causes:

Solution:

Meaning: Battery voltage has dropped below the truck’s minimum operating threshold (typically 36V for a 48V system under load).

Symptoms: Lift speed reduces dramatically; travel speed is limited to “creep mode.”

Causes:

Solution:

Even without a code, the ETV 216 may show: