Hsp06f1s4

If you encountered this string in a real situation, it may have come from:

| Source | Example | |--------|---------| | Blurry photo / OCR error | Original HSP06F154 (S4 misread) or HSP061514. | | Silk‑screen defect on PCB | HSPO6F1S4 (zero vs letter O). | | Internal inventory tag | Temporary reference later overwritten. | | Firmware hex dump | Partial extraction from memory address. | | Scrambled database export | Column shift: real code HSP-06F1 from row S4. |

Action: If you have a physical component, search every surface (including edges and underside) for a secondary code. hsp06f1s4

| Parameter | Min | Typ | Max | Unit | |--------------------------|-----|-----|-----|----------| | Supply voltage | 4.5 | 12 | 24 | V | | Supply current (no load) | – | 6 | 12 | mA | | Output saturation voltage| – | 0.2 | 0.4 | V | | Output leakage current | – | – | 10 | µA | | Rise/fall time | – | 1 | 5 | µs | | Maximum switching freq. | – | 10 | 15 | kHz | | Air gap (steel target) | 0.5 | 1.5 | 3.0 | mm |

The HSP06F1S4 does not have a widely published datasheet. For absolute electrical limits (max current, reverse polarity protection, etc.) and exact timing specs, either: If you encountered this string in a real

If you need a replacement or datasheet without certainty:

Add a 4.7 kΩ series resistor and a 5.1 V Zener diode to clamp output before feeding a 5V MCU. Replace pull-up with a 330 Ω resistor and

Vcc (5–24V) ----> HSP06F1S4 Pin 1
GND ------------> HSP06F1S4 Pin 2
Output Pin 3 ----> 10kΩ pull-up resistor to Vcc ----> Microcontroller/ECU input

Replace pull-up with a 330 Ω resistor and an LED in series to VDD. Output low = LED on.