Gibbscam Post Processor -

For drilling, tapping, and boring cycles:

CYCLE_DRILL: G81 Xx Yy Zz Rr Ff
CYCLE_TAP: G84 Xx Yy Zz Rr Qq Fcalc_feed

When using Transform Operations (Rotate/Translate), Gibbs posts often dump the same 1,000 lines of code four times. Advanced Fix: Enable K_CREATE_SUB logic in the .PST to force the compiler to write a M98 P1000 subprogram for the first operation and simply rotate the coordinate system for the subsequent calls. gibbscam post processor

Specifies numeric output:

The most challenging post processors are those for Mill-Turn machines (e.g., DMG Mori NTX, Mazak Integrex, Okuma Multus). A standard post assumes sequential operations—first the main spindle works, then you stop, then the subspindle works. For drilling, tapping, and boring cycles: CYCLE_DRILL: G81

A Mill-Turn post must handle:

GibbsCAM addresses this with its Advanced Mill-Turn module and specialized post processors that use a Sync Manager. These posts read a synchronized operation list and output code with WAIT and SIGNAL commands (M-codes) to coordinate the spindles. Writing a post like this without vendor support is nearly impossible for an in-house programmer. GibbsCAM addresses this with its Advanced Mill-Turn module