Firstchip Fc1178 Fc1179 Mptools V1052 Link -

Firstchip Fc1178 Fc1179 Mptools V1052 Link -

If v1052 fails:

If v1052 fails repeatedly, try these:

Always match the tool version to the firmware date. If your drive was manufactured after 2021, v1052 might fail. In that case, search for FC1179 MPTools v1106. firstchip fc1178 fc1179 mptools v1052 link

This post covers the Firstchip FC1178 and FC1179 USB-to-UART/serial bridge chips and working with MPTools v1.0.5.2 (the flashing/config utility commonly used with Firstchip-based devices). It explains device differences, typical workflows, common failure modes, precise steps for using MPTools v1.0.5.2, practical debugging tips, and safety precautions. Assumes basic familiarity with serial flashing, drivers, and Windows tooling.

Summary of key takeaways

  • USB ports & cables:
  • MPTools shows “fail to open COM”:
  • Flash/Write fails mid-way:
  • Verify mismatch after write:
  • Device unstable after flash:
  • Driver conflicts (Windows using wrong driver like generic USB driver):
  • VID/PID and MPTools recognition:

    • If you want, I can:

    | Feature | FC1178 | FC1179 | | :--- | :--- | :--- | | Interface | USB 2.0 | USB 3.0 / 2.0 backward compatible | | Speed | Up to 25 MB/s | Up to 100 MB/s | | Common Issue | Corrupt firmware after unsafe eject | Overheating leading to NAND lock | | MPTool Needed | v1052 or newer | v1052 or newer (specific toggle) | If v1052 fails:

    Despite their differences, both controllers use the same MPTool framework. Attempting to use older tools (v1024, v1030) will result in "Device Not Match" or "Bad Block Over Setting" errors. Version 1052 is the earliest stable build that natively supports both chips.

  • When complete, a green “PASS” or “OK” will appear. Total time: 3–15 minutes.