Fg Wilson Dcp-10 Software — Download

| Issue | Solution | | :--- | :--- | | “COM port not found” | Install FTDI driver manually (www.ftdichip.com/Drivers) | | “Checksum error” | Lower baud rate to 9600, then reattempt | | Cable works but no data | Your cable is straight-through; you need a null-modem crossover inside the RJ45. Re-pin: 2↔3, 5↔5 |

Once you have obtained the legitimate installer (e.g., DCP10_Service_Tool_vX.X.exe), follow these steps: fg wilson dcp-10 software download

After installation, you should see a desktop shortcut: DCP-10 Service Tool. | Issue | Solution | | :--- |

Before attempting to install the software, ensure your laptop meets the minimum requirements. Industrial diagnostic software often runs better on older, legacy operating systems due to driver compatibility. After installation, you should see a desktop shortcut:

This is the only official method. If you own an FG Wilson generator, contact the support team where you purchased the unit.

Several online industrial tool vendors sell diagnostic kits that come pre-loaded with the software on a hard drive or USB stick (often marketed as "CAT ET" or "FG Wilson Diagnostic Kits").