Before diving into the button functions, it is essential to understand what the MK6N Genius is. Unlike standard digital readouts, the "Genius" line focuses on adaptive learning and context-sensitive help. The MK6N is a 6-axis DRO (though typically used for 3-axis with expansion) designed to interface with glass scales, magnetic scales, or encoders.
Key specifications at a glance:
The "Genius" in the name refers to the onboard wizard that guides you through complex milling operations, bolt hole patterns, and arc calculations without needing to consult a separate textbook.
To keep your EDMi MK6N Genius operating for a decade or more:
4.1 Mounting Ensure the mounting surface is rigid and free from vibration. If using a panel mount version, cut out the aperture according to the dimensions specified in the technical datasheet (typically approx. 100mm x 150mm depending on the specific chassis). edmi mk6n genius user manual
4.2 Wiring Diagram (Example: 3-Phase 4-Wire)
4.3 Earthing Connect the functional earth terminal to a verified earth ground to ensure user safety and meter immunity to external noise.
The MK6N Genius has a backlit LCD that cycles through various data pages.
To scroll through screens manually:
Note: The exact display sequence can be customized by your utility or system integrator.
Used for QC inspection or surface plates. Disables all tool compensation and simply displays encoder position.
Enable this in SETUP > ALERTS. You can set soft limits. For instance, program a Z-axis lower limit of -50mm. If you approach within 5mm, the screen flashes red. If you cross it, an audible beep sounds.
Q: Can I use the MK6N Genius with 5V TTL scales from another brand? A: Yes. The manual specifies compatibility with any differential or single-ended TTL scale, provided you wire the pins correctly. See Appendix B for pinout diagrams. Before diving into the button functions, it is
Q: Why does my Z-axis reading jump by 0.005" randomly? A: This is typically electrical noise. Ensure your scale cables are shielded and grounded. Also, set the "Noise Filter" in SETUP > ADVANCED to LEVEL 2.
Q: How do I reset the device to factory defaults?
A: Power off. Press and hold the X and Y keys simultaneously, then power on. The screen will ask "Reset all settings?" Press ENTER.
Q: The "Genius" wizard suggests a move that looks wrong. Can I trust it? A: The wizard calculates based on tool center. Double-check cutter diameter compensation. If you are climb milling vs conventional, the offset direction changes.
| Symptom | Possible Cause | Corrective Action | | :--- | :--- | :--- | | Blank Display | No power supply. | Check voltage supply to terminals. Check fuses/breakers. | | Energy Not Counting | Wiring error or Low Load. | Verify CT polarity. Check if load is below the starting threshold. | | Erratic Reading | High interference or bad earth. | Ensure meter earth is connected. Check for ground loops on RS485. | | BAT Icon Lit | Internal battery low. | Contact utility or vendor for battery replacement to maintain RTC. | The "Genius" in the name refers to the