If you are installing a used Cobra 3195, the full manual provides a 7-pin and 12-pin connector layout. Here is the essential wiring:
The above guide is a summary intended to give you a functional understanding of the Cobra 3195 alarm system without reproducing copyrighted text from the official manual. For detailed wiring diagrams, regulatory compliance information, or advanced configuration (e.g., integrating with third‑party home‑automation platforms), you should obtain the full, up‑to‑date manual from the sources listed in section 9. cobra 3195 alarm manual full
| Button | Function | Typical Use | |--------|----------|-------------| | MENU | Access configuration screens | Changing settings, adding users, etc. | | ▲ / ▼ | Navigate up‑down or increase/decrease values | Adjusting numbers, scrolling menus | | ENTER | Confirm selection | Saving changes, arming/disarming | | ARM | Initiate arming sequence | Quick arm (default mode) | | TEST | Run a sensor test | Verify each zone works | | SILENCE | Mute audible alarm | When a false alarm occurs | | LED indicators | | Quick visual status at a glance | If you are installing a used Cobra 3195,
Before we dive into custom programming, here are the legitimate sources to download the full original manual: | Button | Function | Typical Use |
Fix: Replace remote battery (CR2032). Then re-learn remote (Section 3.2). Also ensure the alarm’s antenna wire (thin black wire) is not coiled or cut – extend it straight up behind the dashboard.
While in Learn Mode (siren chirped 3 times):
Pro tip: If no remote works afterward, you may have entered “Delete All” mode accidentally. To reset, perform the learn process with no remote presses for 15 seconds.