Turn the water on full cold, then full hot. Check the connection point. A single drip means you need an extra 1/8th turn. A steady leak means you have a cracked washer or cross-threaded nut.
The V200 looks simple, but its internal vortex requires specific water dynamics to work. Here is the standard operating procedure. caraflo v200 shower instructions
Before using the unit, ensure the following safety measures are observed to prevent injury or damage to the unit: Turn the water on full cold, then full hot
| Symptom | Likely cause | Action | |---|---:|---| | No power | Blown fuse / tripped RCD / no supply | Check isolator, test RCD, replace fuse; call electrician if needed | | Tripping RCD | Earth fault / water ingress | Isolate, cease use, call electrician | | Low flow | Blocked filter / low mains pressure | Clean filters, check supply valve, check household demand | | Temp unstable | Pressure fluctuations / limescale | Reduce other water use, descale, seek service if persists | | Leak | Loose fitting / failed seal | Tighten joints, replace seal, call service if internal leak | The V200 looks simple, but its internal vortex
(Apply manufacturer-specific specs from unit label/manual for pressures, electrical rating, and part numbers when ordering spares.)