Walk your perimeter before drilling. Ask these questions:
Set the following for initial testing: | DIP Switch | Setting | Function | |------------|---------|----------| | SW1 | OFF | Pulse count = 1 (most sensitive) | | SW2 | OFF | Pulse count = 1 (continued) | | SW3 | ON | LED enabled (useful for walk testing) | | SW4 | OFF | Normal alarm output |
| Connection | Details | |------------|---------| | Power | 24V DC @ 2.5A, terminal block L+/M | | Protective Earth | Connected to chassis ground (0.5 ohm) | | Ethernet | Port 1 → Plant LAN (static IP 192.168.1.100) | | RS485 | Terminals A/B, 120 ohm termination enabled | | Digital Inputs (4x) | Dry contact, 24V logic | | Relay Outputs (2x) | NC/NO, rated 5A @ 30VDC |
| Symptom | Likely Cause | Solution | |---------|--------------|----------| | Night-only alarms | Animal activity (cats, raccoons) | Increase pulse count to 2 (DIP SW1=ON, SW2=OFF) | | Wind alarms | Tree branches or fence movement | Mask PIR zones with tape or reduce PIR pot | | Random alarms | Voltage drop or RF interference | Use shielded cable, verify power |
Walk your perimeter before drilling. Ask these questions:
Set the following for initial testing: | DIP Switch | Setting | Function | |------------|---------|----------| | SW1 | OFF | Pulse count = 1 (most sensitive) | | SW2 | OFF | Pulse count = 1 (continued) | | SW3 | ON | LED enabled (useful for walk testing) | | SW4 | OFF | Normal alarm output | aqmos r2d272 installation new
| Connection | Details | |------------|---------| | Power | 24V DC @ 2.5A, terminal block L+/M | | Protective Earth | Connected to chassis ground (0.5 ohm) | | Ethernet | Port 1 → Plant LAN (static IP 192.168.1.100) | | RS485 | Terminals A/B, 120 ohm termination enabled | | Digital Inputs (4x) | Dry contact, 24V logic | | Relay Outputs (2x) | NC/NO, rated 5A @ 30VDC | Walk your perimeter before drilling
| Symptom | Likely Cause | Solution | |---------|--------------|----------| | Night-only alarms | Animal activity (cats, raccoons) | Increase pulse count to 2 (DIP SW1=ON, SW2=OFF) | | Wind alarms | Tree branches or fence movement | Mask PIR zones with tape or reduce PIR pot | | Random alarms | Voltage drop or RF interference | Use shielded cable, verify power | Set the following for initial testing: | DIP