Alcor Micro Unknown Fa00 - F W 3613

FAQs

By Address

Enter a corporate or residential street address, city, and state to see a specific ZIP Code^™.

Find by Address

By City and State

Enter city and state to see all the ZIP Codes^™ for that city.

Find by City & State

Cities by ZIP Code^™

Enter a ZIP Code^™ to see the cities it covers.

Find Cities by ZIP

Can't find what you're looking for?

Go to our FAQs section to find answers to your ZIP Code^™ questions.

Alcor Micro Unknown Fa00 - F W 3613

Progress bar: 2–10 minutes. If stuck at 50%, the NAND is likely dead.

| Symptom | Likely Cause | Solution | |---------|--------------|----------| | MPTool shows “Not support flash” | NAND chip is dead or not in tool’s DB | Replace NAND (not worth it for cheap drives) | | MPTool hangs at “Check ID” | Short circuit or damaged controller | Discard drive | | Drive disappears after eject | Poor solder joints | Reflow controller with hot air (advanced) | | PID remains FA00 after MP | Wrong firmware version | Try older MPTool (v13.01 for 3613) | | Only 8MB capacity after repair | NAND failed, controller in ROM mode | Drive is dead |

Seeing "Unknown FA00 - F W 3613" is rarely a good sign. It usually points to one of three scenarios: alcor micro unknown fa00 - f w 3613

If none of the above works, consider the physical context of the alcor micro unknown fa00 - f w 3613. Progress bar: 2–10 minutes